Belt-On-Roller Conveyor

The flat carrying surface of the Model 410 safely moves a variety of loose and irregularly-shaped items. The belt, available in either low friction or ruff top versions, is supported by rollers with low-friction bearings allowing heavy loads to travel over long distances with ease. Horsepower requirements are surprisingly low. Standard center drive units are suitable for two way operation

 

 

 

 

 

 

 

 

.

 

 

 

 

 

 

 

Standard Specifications: Model 410 Belt-On-Roller

Width: 12-¼", 18-¼", 24-¼", 30-¼"

Frame: 6-¼" deep, 10 gage channel painted steel. 12' long bed sections

Center Drive: 8" diameter drive pulley with a 2-7/16" diameter shaft stepped down to 1-7/16"

Belt Take-Up: 14" of manual screw take-up in the center drive

Speed: 60 fpm

Motor: ¾ hp C-Face, 208/230/460/480 volt, 60 cycle, 3 phase, totally enclosed

End Pulley: 4" diameter pulley with a 1-7/16" diameter shaft

 Pop-Out Safety Rollers: Located at each end of the conveyor

Rollers: Carrier and return - 1.9" diameter, 16 gage, steel with plated bearing shell, steel balls, unsealed and greased

Axles: 7/16" hex steel on 8" centers

Belt: Black PVC-90 friction surface x friction surface; 8", 12", 18", 24" widths

Supports: 24" to 36" adjustable floor supports at each end and at bed joints. (For conveying surface height, add frame depth.) Diagonal braces at each end and an extra pair for conveyors over 50' long. For other support heights, see the Accessories: Supports page.

Electrical Controls: See the Controls page.

Guard Rail: See the Guard Rail page.

 

 

 

 

 

 

Optional Specifications: Model 410 Belt-On-Roller

Motor: ¾ hp single phase, 115/230V.
1 hp, 3 phase, 208/230/460/480V.
1 hp, single phase, 115/230V.
Also available w/brake.		 End Drives: One way operation. 5' of slider bed, 4" or 8" diameter drive pulley and pop-out safety roller. Conveyor end assembly has 8" of belt take-up. ¾ hp maximum for 4" diameter pulley drives.
Incline/decline conveyors are available. Call for assistance on selecting the following options:
Belt: Ruff top x friction surface

Nose-Over: 15º to 22-½º. Includes 4" end pulley and an end pop-out roller, and one 24" to 36" adjustable floor support.

Return Belt Roller Guards: Required on inclined conveyors from 30" above floor level to 8' 0".

 Power Feeder: Attaches to low end of main conveyor and is slave driven. Belt speed of a feed-on power feeder is 50 fpm.

Feed-off unit's belt speed is 73 fpm. 4" diameter pulleys, pop-out end roller and 8", 12", 18", or 24" belt width, and one 24" to 36" adjustable floor support.